2 operating the amplifier – Multichannel Systems STG3008-FA Manual User Manual
Page 19
Operating the STG
13
STG and Stimulus Protocol Information:
4.2 Operating
the
Amplifier
Switching between Stimulation and Recording Mode
The STG3008-FA is a stimulus generator of STG3000 series combined with a filter amplifier
with four selectable gain factors: 100, 200, 500, or 1000.
Please click "Edit" menu and select "Filter Amplifier Control".
The “Filter Amplifier Control” settings are saved in the current MC_Stimulus II protocol.
After download, the STG3008-FA is set accordingly.
Thus, it is easy to switch between different measuring or stimulation settings by loading several
MC_Stimulus II worksheets. Then you can download the protocol with the desired settings.
If the STG3008-FA is switched off and on again, the settings for all eight channels are reset
to “Measure”, and the last downloaded filter amplifier gain is retained. This reset enables
measurements with the STG3008-FA without using the MC_Stimulus II software, of course
without stimulation, respectively.