Multichannel Systems STG3008-FA Manual - Manual (Page 66)

STG3008-FA Manual
60
11.2 Voltage Mode
 If you want to operate the STG in voltage mode, you have to select "Voltage" in Output Mode
of the main window of MC_Stimulus II. You will usually use the + and GND outputs. The output
signal is identical with the programmed signal in the normal ranges of the electronics' accuracy.
The output signals are inverted (multiplied by -1) if you use the - outputs.
 In the following example, you see a signal in the MC_Stimulus II display and the resulting
output signals for the different connection options (viewed in a MC_Rack Data Display).
Programmed stimulus protocol viewed in MC_Stimulus:
STG output signals:
Programmed stimulus protocol viewed in MC_Stimulus II.