Service – Diamond Products Fast-Cut SLR User Manual
Page 11
11
Maintenance
- Before performing maintenance work switch off the Fast-
cut (27) and pull out the plug cap.
- Allow the Fast-cut to cool off before doing any maintenance
work (burn hazard)!
- Fast-cuts with catalytic converter take longer to cool
down!
- Always check the Fast-Cut before using it to make sure that
it is in good working order. In particular, make sure that the
cutting disc is properly mounted. Make sure that the cutting
wheel is undamaged and suitable for the job it will be used
for.
- Operate the Fast-Cut only at a low noise and emission level.
For this ensure the carburetor is adjusted correctly.
‑ Do not operate the Fast‑Cut with a defective or modified muf-
fler.
- Clean the Fast-Cut regularly.
- Check the fuel tank cap regularly for good sealing.
Observe the accident prevention instructions issued by
trade associations and insurance companies. NEVER
make any modifications to the Fast-Cut! You will only be
putting your own safety at risk!
Perform only the maintenance and repair works described in
the instruction manual. All other work must be carried out by
Diamond Products Service.
Use only original Diamond Products spares and accesso-
ries.
The use of non-Diamond Products spares, accessories, or
cutting discs increases the risk of accident. We cannot ac-
cept any responsibility for accidents or damage occurring in
association with the use of cutting discs or accessories other
than original Diamond Products.
First aid
For the event of a possible accident, please make sure that a
first aid kit is always immediately available close by. Immediately
replace any items used from the first aid box.
When calling for help, give the following information:
- Place of the accident
- What happened
‑ Number of injured people
- Kind of injuries
- Your name!
NOTE
Individuals with poor circulation who are exposed to excessive
vibration may experience injury to blood vessels or the nervous
system.
Vibration may cause the following symptoms to occur in the fin-
gers, hands or wrists: ”Falling asleep” (numbness), tingling, pain,
stabbing sensation, alteration of skin colour or of the skin. If any
of these symptoms occur, see a physician!
Disposal and environmental protection
Be mindful of the environment!
Dispose of worn-out or defective cutting discs in accordance with
your local disposal regulations. To protect unusable cutting discs
from misuse, destroy them before disposal.
When the Fast-Cut is worn out or damaged beyond repair, have
it disposed of or recycled in an environmentally sound manner. If
necessary, consult your local authorities.
27
28
29
SERVIcE