Diamond Products Fast-Cut SLR - Manual (Page 21)

21
MAINTENANcE
cAUTION:
Before doing any work on the Fast-cut turn off the engine,
remove the cutting disc, pull the plug cap off the spark plug
and wear protective gloves!
cAUTION:
Start the Fast-cut only after complete assembly and in-
spection.
IMPORTANT:
Because many of the parts and assemblies not mentioned
in this Instruction Manual are vital to the safety of the
unit, and because all parts are subject to a certain amount
of wear and tear, it is important for your own safety that
you have the unit checked and maintained regularly by a
Diamond Products service center.
IMPORTANT:
If the cutting wheel breaks during cutting, the
Fast-cut must be repaired by a Diamond Products
service center before being used again!
SERVIcE
Unscrew the screws (8) and remove the crankcase housing
cover (9).
Remove the old belt (10) or belt pieces.
NOTE: The illustration shows the V-belt for models FC7312
and FC7314).
Clean out the inside of the drive arm with a brush.
Put in a new V-belt.
NOTE:
Reassemble the crankcase housing cover (9), side piece (6)
and cover (4) in the reverse order.
To tighten the V-belt see ”Tightening the V-belt / checking
V-belt tension”.
changing the V-belt
Loosen nuts (3).
Loosen the tightening screw (1) (counter-clockwise) until the
end of the screw (2) is visible in the gap.
Loosen and unscrew the screw (detail X, only for SC-
8116XL).
Unscrew the nuts (3) and remove the cover (4).
Remove the screws (5) and (7) and remove the side piece
(6).
NOTE:
Screw (5) is longer than screws (7). Make sure
to put them back in the right places during reas-
sembly!