Diamond Products Fast-Cut SLR User Manual

Page 27

Advertising
background image

27

cutting attachment in

central / side position

NOTE: The Fast-Cut is delivered with the cutting attachment

mounted in the middle position (1). For cutting up against ob-

stacles, such as curbs or walls, the cutting attachment can be

mounted to one side (2). Use this position only when actually

necessary, and afterwards return the cutting attachment to the

middle position
In this position the Fast-Cut has better balance, is easier to

guide, and is not as fatiguing for the operator.

Use the combination tool (8) to lever out the stop pin (9) as

shown in the illustration, until the protective hood (11) can be

turned.
NOTE: The turn stop (7) is deactivated when the stop pin (8) is

removed. This permits the hood (11) to be turned farther than

the turn stop (7).
Unscrew the grip (10) and turn the protective hood (11) as

shown in the illustration.
Disengage the V-belt (12) and remove the cutting attach-

ment.
NOTE: The illustration shows the V-belt for models FC7312

and FC7314).

8

9

10

11

12

Repositioning the cutting attachment

Loosen nuts (5).
Loosen the tightening screw (3) (counter-clockwise) until the

end of the screw (4) is visible in the gap.
Loosen and unscrew the screw (detail X, only for SC-

8116XL).
Unscrew the nuts (5) and remove the cover (6).

Advertising