Diamond Products Fast-Cut SLR User Manual

Page 19

Advertising
background image

19

Stopping the engine

Push the combination switch (6) down to position .

6

Warm starting:

As described above for cold starting, but before starting push

the combination switch (6) up (Choke position) and then right

away back to the middle “I” position.
This is only to engage the half-throttle lock. If the engine doesn’t

start after 2 or 3 pulls, repeat the entire starting procedure as

described for cold starting.
Do not leave switch in the choke position when hot

starting!

cold starting:

Grasp front handle firmly with one hand and press the Fast‑Cut

against the ground.
Place left toe in the rear handguard.
Push the combination switch (6) up (choke position). This will

automatically activate the half-throttle lock.
NOTE: If the Fast-Cut is mounted on the trolley, do not operate

the gas lever (throttle) on the side of the trolley!
Pull the starter cable out slowly until you feel resistance (piston

is now just before top dead center).
Press in the decompression valve (5).
Pull starter cable quickly and firmly, until you hear the first

ignition, but to a max. of 3-5 pulls!
Important:
Do not pull the starter cable out more than about

50 cm / 20”, and guide it back slowly by hand (instead of letting

it snap back).
Press in the decompression valve (5).
Move the combination switch (6) to the middle “I” position.

Again pull the starter cable quickly and firmly.
As soon as the engine is running, grasp the rear handle (

the

safety lock switch

(8)

will be depresse

d by the palm of your hand)

and tap the throttle (9).

The half-throttle lock will be disengaged

and the engine will run in idle.

cold start (choke)

Warm start

Engine off

5

8

9

6

Advertising