Nova-Tech B4000-16 - Manual (Page 20)

6
Instructions manual
6. Operation
6.1 Power on
6.1.1 Open the chamber door and remove all inner packing and
accessories.
6.1.2 Plug the power cord into the proper electrical outlet. (Please
check that the power source is in accordance to the electrical
specifications of the machine (listed on the power label).
6.1.3 Power on - The switch is located underneath the control panel
on the front side of the machine.
6.2 Filling the water tank
Open the top lid, and fill the tank with water. The water should
be filled within approximately 1 inch of the black seal. If you hear a beep
signal, the max water level is exceeded. Please stop filling immediately.
distilled
Following power up, the control panel illuminates.
The Time window will display “Ld” .
6.3 Sample Preperation
For the most effective sterilization and to preserve the sample, please
follow below:
* Arrange the samples of different material on different trays or with at least
2in. of space between them.
* Always insert a sterilization paper or cloth between the tray and sample,
to avoid direct contact between the different materials.
1 7
13. Service and Contact
Instructions manual
For additional information on any of the error codes listed in section
10, please contact your sales representative, or contact Biomega
Research Products Service Department at 1-908-769-5555. Please
have the unit’s serial number (located on the back panel of the
instrument) available when calling. Do not send in a unit for service
without first calling to obtain a repair authorization number and a
decontamination form. The unit should be properly packed to avoid
damage. Any damage resulting from improper packing shall be the
responsibility of the user.