Horz. distance – PASCO ME-6825A MINI LAUNCHER User Manual

Page 18

Advertising
background image

Mini Launcher

012-05479B

®

16

Angle

10 20 30 40 50 60 70 80

1

2

3

4

5

Average

Paper

Dist.

Total

Dist.

Horz. Distance

Table 3.1 Shooting on a Level Surface

where y

o

is the initial height of the ball and y is the position of the ball when it hits the floor.

Setup

➀

Clamp the Mini Launcher near one end of a sturdy table with the Launcher aimed so the ball will land on

the table. The square nut in the T-slot should be positioned near the muzzle.

➁

Adjust the angle of the Mini Launcher to ten degrees.

➂

Put the steel ball into the Mini Launcher and cock it to the chosen position.

Procedure

SHOOTING ON A LEVEL SUR-
FACE

➀

Fire one shot to locate where the
ball hits the table. At this position,
tape a piece of white paper to the
table. Place a piece of carbon paper
(carbon-side down) on top of this
paper and tape it down. When the
ball hits the table, it will leave a
mark on the white paper.

➁

Fire about five shots.

➂

Measure the horizontal distance from the launch position of the ball to the leading edge of the paper.
Record in Table 3.1.

➃

Measure from the leading edge of the paper to each of the five dots and record these distances in Table

3.1.

Figure 3.3: Setup to shoot on level surface

Advertising