PASCO PS-2106A Light Sensor - Manual

Instruction Sheet
012-09835B
Light Sensor
PS-2106A
.
*See the PASCO catalog or the PASCO web site at www.pasco.com
for more information.
Introduction
The PS-2106A Light Sensor measures illuminance in units
of lux. Illuminance is a measure of how much the incident
light illuminates a surface, and is the total luminous flux per
unit area. The lux is a lumen per square meter. The lumen
(Systeme International (SI) unit) is defined in relation to the
candela, one of the SI base units.
The sensor is designed to work with a PASPORT-compatible
interface (such as the UI-5100 850 Universal Interface) and
PASCO data acquisition software (such as PASCO Cap-
stone) to measure illuminance.
The sensor includes a sensor mounting stud that can be
screwed into the threaded hole on the side of the sensor. The
sensor mounting stud can then be attached to a support rod
using a clamp.
The Light Sensor has a three ranges which are represented
by the icons next to the range select buttons. The candle
range is 0 to 2.6 lux, the light bulb range is 0 to 260 lux, and
the sun range is 0 to 26,000 lux.
Setup the Light Sensor
• Plug the sensor into one of the PASPORT input ports of
a PASCO PASPORT-compatible interface.
NOTE: If more distance is needed between the sensor and
the interface, plug the sensor into the included Sensor Exten-
sion Cable, and then plug the cable into the interface.
• Start the PASCO data acquisition software.
Using PASCO Capstone Software
• Click the “Hardware Setup” icon in the Tools palette to
open the “Hardware Setup” panel. Confirm that the
Light Sensor icon appears with the interface’s icon.
Light
Port
Threaded Hole
Range Select
Buttons
Included Items
Light Sensor
Sensor Mounting Stud
Required Items*
PASCO Interface
PASCO Data Acquisition Software
Recommended Item*
Sensor Extension Cable (PS-2500)
Sensor
PASPORT
Input Port
Interface