PASCO PS-2143 Quad Temperature Sensor - Manual

Instruction Sheet
012-08656D
Quad Temperature Sensor
PS-2143
.
*See the PASCO catalog or the PASCO web site at www.pasco.com
for more information.
Introduction
The PS-2143 Quad Temperature Sensor measures tempera-
ture from up to four temperature probes simultaneously in
units of degrees celsius, fahrenheit, and kelvin (°C, °F, °K).
The sensor includes two Stainless Steel Temperature Probes
(PS-2153), three Fast Response Temperature Probes
(PS-2135), a piece of polyurethane tubing, and a sheet of
adhesive disk covers. The tubing can be used when a Stain-
less Steel Temperature Probe is inserted into a stopper, and
the adhesive disk covers can be used to hold the end of a Fast
Response Temperature Probe in place.
The sensor is designed to work with a PASPORT-compatible
interface and PASCO data acquisition software (such as
PASCO Capstone) to measure temperature.
Setup the Sensor
• Plug the sensor into one of the PASPORT input ports of
a PASCO PASPORT-compatible interface.
NOTE: If more distance is needed between the sensor and
the interface, plug the sensor into a Sensor Extension Cable,
and then plug the cable into the interface.
• Plug one or more temperature probes into the sensor.
• Start the PASCO data acquisition software.
Objects are not to scale.
Fast Response Temperature Probe
Stainless Steel Temperature Probe
Included Items
Quad Temperature Sensor
Stainless Steel Temperature Probe (2)
Fast Response Temperature Probe (3)
Polyurethane Tubing (0.3 m)
Adhesive Cover Disks (1 sheet)
Required Items*
PASCO Interface
PASCO Data Acquisition Software
Recommended Items*
Sensor Extension Cable (PS-2500)
Teflon
®
Sensor Covers (CI-6549)
Sensor
PASPORT
Input Port
Interface