PASCO CI-6532A PRESSURE SENSOR - ABSOLUTE User Manual

Page 2

Advertising
background image

Pressure Sensor - Absolute (0 to 700 kPa)

012-06859B

2

Range and Resolution

The range of the CI-6532A Absolute Pressure

Sensor is between 0 and 700 kiloPascals (or 0 to

6.9 atmospheres). Atmospheric pressure is

normally around 101.326 kiloPascals (kPa).

Pressure can be measured in many different units

(e.g., atmospheres, inches of mercury, millimeters

of mercury, kiloPascals, Bar, pounds per square

inch). Some equivalent values for pressure are:

1 atmosphere = 30.00 in of Hg (at 16ºC)

= 760 millimeters of Hg

= 101.326 kiloPascals (kPa)

= 1.013 Bar = 1013 milliBar

= 14.696 pounds per square inch (psi)

The top of the range of pressure expressed in these

equivalent units is as in Table 1.

The maximum short-term pressure that the sensor

can tolerate without permanent damage is about

1,000 kPa (150 psi). Please be careful to not apply

high pressure to the sensor.

The output voltage from the sensor is +1.00 Volts

when the pressure is 100 kiloPascals (kPa), and the

output voltage is linear. Therefore, the output

voltage should be +7.00 Volts at the top of the

range (700 kPa). The resolution of the sensor is 0.5

kPa (when used with a PASCO computer

interface). This resolution translates into other

pressure units as follows:

Units

Resolution

inches of Hg

0.148

mm of Hg

3.750

milliBar

5.088

pounds per square inch (psi)

0.072

atmospheres

0.004

The sensor box contains a precision operational

amplifier (op amp) that can drive a heavy

capacitive load, such as a six meter extender cable

(CI-6515). There is a resistor in parallel with the

transducer to compensate the sensor for

temperature induced variations. The sensor has a

negative temperature coefficient (resistance

decreases as temperature increases) and the resistor

has a positive temperature coefficient.

Operation

Setting up the Equipment

1. Connect the Pressure Sensor unit to analog

channel A, B, or C of the Science Workshop

computer interface box using the cable with

the DIN connectors (Figure 1). Alternatively,

the unit can be plugged directly into the

analog channel jack.

700 kPa MAX

DRY

AIR

ONL

Y

PRESSURE PORT MA

TING

CONNECT

OR:

PASCO P

ART NO. 640-021

PRESSURE

SENSOR

0-700 kPa

(ABSOLUTE)

CI-6532A

Figure 1
Connecting the amplifier box to the interface box

kiloPascals

inches of Hg

mm of Hg

Bar

pounds/sq in atmospheres

700.00

207.25

5250.4

6.999

101.48

6.908

101.32

30.00

760.0

1.013

14.69

1.000

Table 1
Pressure range comparison

Advertising