PASCO ME-8952 Centripetal Force Accessory - Manual

Instruction Sheet
for the PASCO
Model ME-8952
Centripetal Force Accessory
012-05294B
10/94
$1.00
Phone (916) 786-3800 • FAX (916) 786-8905 • TWX 910-383-2040
10101 Foothills Blvd. • P.O. Box 619011 • Roseville, CA 95678-9011 USA
better
teach physics
ways to
© 1994 PASCO scientific
This instruction sheet written by: Ann and Jon Hanks and
edited by: Eric Ayars
Introduction
The ME-8952 Centripetal Force Accessory is comprised
of two vertical posts which can be mounted to the
Rotating Platform with thumbscrews. These posts are
adjustable and can be positioned virtually anywhere along
the length of the platform. The radius indicator is at the
center of the apparatus so it can be clearly seen while the
apparatus is rotating. The PASCO Centripetal Force
Accessory can be used to experiment with centripetal
force and conservation of angular momentum. For the
centripetal force experiments it is possible to vary the
mass and radius to see the resulting change in the centrip-
etal force. The force can also be held constant while other
quantities are varied. The Centripetal Force Accessory is
powered by hand and the rate of rotation can be counted
manually or read by a computer. Variable hanging masses
are included. This accessory requires the Rotating
Platform (ME-8951) to operate.
See the Complete Rotational Manual for experiment
guide.
clamp-on
pulley
side post
center post
50g masses
100g mass with 3
open hooks
Equipment
The ME-8952 Centripetal Force Accessory includes:
- center post that supports an indicator mechanism
which consists of a small pulley, a movable
spring holder, a movable indicator, a rivet, a
spring, and a plastic indicator disk
- side post for hanging hooked mass
- mass (100 g) with 3 open hooks
- 2 additional 50 gram masses
- clamp-on pulley
plastic
indicator disk spring
rivet