PASCO ME-9469 ADJUSTABLE END STOP - Manual

Instruction Sheet
for the PASCO
Model ME-9469
ADJUSTABLE END STOP
012-04990B
2/93
$1.00
Introduction
The PASCO Model ME-9469 Adjustable End Stop is
designed for use as an accessory to any PASCO
Dynamics Track or Introductory Dynamics System.
When used with the magnetic Collision Cart or the
optional magnets in the Dynamics Cart end caps the
End Stop functions as an elastic collision bumper. It
becomes an inelastic bumper in experiments where the
hook and pile tabs on the cart contact those of the End
Stop. The End Stop can also be used as a solid bumper
for the
ME-9430 Dynamics Cart plunger.
Additional Equipment Required:
• Dynamics Cart Track, such as Model ME-9434 or
ME-9435
• Dynamics Cart, such as Model ME-9430
Additional Equipment Recommended:
• Collision Cart, such as Model ME-9454
ä CAUTION: The Adjustable End Stop con-
tains two neodymium magnets. Keep this
equipment away from any magnetic media.
Solid Bumper
Inelastic Collision
Setup procedure
➀
Loosen the thumbscrew of the Adjustable End
Stop.
➁ Align the square nut within the groove on the de-
sired side of the Dynamics Cart Track.
ä NOTE: The flat side of the square nut must face
the outside of the Dynamics Cart Track as shown.
➂
Locate the End Stop over the desired position and
tighten the thumbscrew.
Hook and pile
Neodymium Magnets
Elastic Collision
Thumb screw
(610-181 +
620-067)
Square nut
(614-054)
Magnet 2X
(634-022)
End Stop
(648-04982)