PASCO WA-9870 Wave Driver Post (2) User Manual
Wave driver post (2) installation instructions, Instruction sheet for the pasco model wa-9870
Instruction Sheet
for the PASCO
Model WA-9870
Wave Driver Post (2)
Installation Instructions
012-08754A
© 2004 PASCO scientific
Introduction
The WA-9870 Wave Driver Post provides a set of two
posts to be glued to any 5 1/4-inch speakers as indi-
cated in Figure 1.
Equipment required but not included:
- Glue; preferrably RTV (black or clear)
Assembling the Plumb Bob
1. Carefully draw an even bead of RTV around the
internal perimeter of the speaker.
2. Allow the RTV to dry according to manufacturer’s
recommendations before setting the post in place.
Assure that the seal around the post is complete.
Figure 1. Alignment of Post on Speaker
better
teach science
ways to
Phone (916) 786-3800 • FAX (916) 786-8905 • web: www.pasco.com
10101 Foothills Blvd. • P.O. Box 619011 • Roseville, CA 95678-9011 USA
®
RTV placement
post
speaker