Leveling, Rod mounting, Disassembly – PASCO ME-6960 PASTrack User Manual

Page 2: For best results, Technical support

Advertising
background image

®

P A S tr a c k

M E- 6 9 6 0

2

2.

Slide the other track section onto the connector piece. Push it
until it snaps.

3.

Turn the track upside down and tighten the screws on the
connector (part a in figure 1).

Leveling

1.

Set the track upright on a level surface.

2.

Place a cart on the track to test it for level.

3.

Adjust the feet to make the track straight and level.

4.

Tighten the locknut of each foot (part e in figure 1).

Rod Mounting

You can use a horizontal rod to elevate one end of the PAStrack
to incline it or two horizontal rods to raise the entire track for dis-
play. The PAStrack accepts rods up to 9.5 mm in diameter (such
as PASCO part SA-9242).

Insert a rod into one of the rod clamp holes (figure 2) and secure
it by tightening the rod clamp screw (part c in figure 1). Clamp
the horizontal rod to a vertical rod.

Figure 2

Disassembly

1.

Loosen the connector screws.

2.

Press and hold the release tabs on the bottom of the track
(part b in figure 1).

3.

Pull the track sections apart.

For Best Results

•

Engage and disengage each new connector several times to
break it in and make subsequent assembly easier.

•

If one end of the PAStrack is elevated, ensure that the con-
nector screws are tightened to prevent the track from bow-
ing.

•

If you are using multiple PAStracks joined together on a
level surface, leave the connector screws loose. This will
make each joint slightly flexible and allow you to use the
feet to level each section separately.

•

To protect your PAStrack during storage, disassemble it and
keep it in its original box.

Technical Support

For assistance with any PASCO product, contact PASCO at:

Limited Warranty

For a description of the product warranty, see the

PASCO catalog.
Copyright

The PASCO scientific 012-10384A

PAStrack Instruction

Sheet is copyrighted with all rights reserved. Permission is granted to
non-profit educational institutions for reproduction of any part of this man-
ual, providing the reproductions are used only in their laboratories and
classrooms, and are not sold for profit. Reproduction under any other cir-
cumstances, without the written consent of PASCO scientific, is prohibited.
Trademarks

PASCO and PASCO scientific are trademarks or registered

trademarks of PASCO scientific, in the United States and/or in other coun-
tries. All other brands, products, or service names are or may be trade-
marks or service marks of, and are used to identify, products or services
of, their respective owners. For more information visit
www.pasco.com/legal.

Address: PASCO scientific

10101 Foothills Blvd.
Roseville, CA 95747-7100

Phone:

916-786-3800 (worldwide)
800-772-8700 (U.S.)

Fax:

(916) 786-7565

Web:

www.pasco.com

Email:

[email protected]

Advertising