PASCO ME-9838 Hovercraft - Manual (Page 4)

Hovercraft Model No. ME-9838
4 ®
Introduction
PASCO's Hovercraft is designed to help students experience frictionless motion, thus better
understand Newton's Laws. Its large platform provides enough area for the rider to
comfortably sit while riding. In addition, the durable Nylon skirt will withstand the rigors of
the classroom environment.
The optional Cordless Air Source (SE-8806) is a convenient way supply air to the Hovercraft,
however most vacuums/blowers used in a wood shop will also be sufficient to lift the
Hovercraft.
The Hovercraft is available in two varieties:
• Hovercraft (ME-9838) is assembled and ready to use
• Hovercraft Kit (ME-9878) requires the addition of the wood platform and needs to be
assembled according to the included instructions and drawings (See pages 8-9).
Equipment Setup and Basic Operation
1. Place the Hovercraft on a smooth, non-carpeted surface such as tile or wood flooring. An
unobstructed space of 10 meters in all directions is ideal.
2. Sit down in the center of the platform.
3. Connect the air source to the platform using the provided tubing or by inserting the blower
tube directly into the opening on the platform.
4. If using the tubing, a screwdriver is required to tighten the clamp around the blower output
tube.
5. Turn on the air source to inflate the Hovercraft skirt.
6. As the skirt inflates, the rider should center his/her weight using the level mounted on the
platform. If the rider is not centered, friction may be introduced.
7. Provide a brief push to the rider on the Hovercraft and observe the resulting motion.
NOTE: Never stand on the Hovercraft as it is very easy to lose your balance and fall.