PASCO ME-6617 ROCKET ENGINE TEST BRACKET User Manual

Page 2

Advertising
background image

Rocket Engine Test Bracket

012-06418A

2

Important Safety Notes

➤

Read all the warnings and follow the instructions provided with the Estes Model Rocket Engine and Igniter.

➤

Review the National Association of Rocketry (NAR) Safety Code prior to igniting a rocket engine. Point

number 9 of the NAR Safety Code is of particular importance:

“The system I use to launch my model rocket will be remotely controlled and electrically operated. It

will contain a launching switch that will return to “off” when released. The system will contain a

removable safety interlock in series with the launch switch. All persons will remain at least 15 feet (5

meters) from the model rocket when I am igniting model rocket engines totalling 30 newton–seconds

or less of total impulse . . . I will use only electrical igniters recommended by the engine manufac-

turer that will ignite model rocket engines within one second of actuation of the launching switch.”

➤

Choose an asphalt or concrete launch area free of any combustible material, animals, or people.

➤

Use a remote electrical launching system that includes a safety key feature to ignite the model rocket engine.

Remote electrical launching is the only safe and approved way to ignite model rocket engines.

➤

Install igniters only when you are outdoors and almost ready to launch.

➤

Wear safety glasses when installing the igniter and connecting the cables to the launch controller.

➤

Never put the safety key in the launch controller unless the exhaust area of the rocket engine is clear.

Otherwise, accidental ignition causing injury may result.

➤

Before igniting the rocket engine, check to be sure there are no objects, people, or animals near the exhaust of

the model rocket engine.

➤

Remove the safety key as soon as the rocket engine is ignited.

➤

Do not allow the igniter leads or alligator clips on the cables to touch each other.

➤

Wait 10 minutes after ignition of the rocket engine before touching the Rocket Engine Test Bracket—it will

be hot.

➤

Comply with any regulations from your state or country for igniting rocket engines.

➤

Use ony Series A–D Estes model rocket engines.

➤

In the event of a misfire, remove the safety key from the controller and wait 60 seconds before disconnecting

the micro-clips. Then replace the igniter.

➤

Never store or transport model rocket engines with igniters installed.

Advertising