Procedure, Questions – PASCO OS-8529 SLIT ACCESSORY User Manual

Page 12

Advertising
background image

8

Slit Accessory

012–06348A

Procedure

➀

Follow the setup procedure on page 2 of the manual using the

Multiple Slit Set with the single-double slit comparison selected.

➁

Sketch the two side-by-side patterns roughly to scale.

➂

Rotate the slit disk to the next comparison set (2 double slits with
the same slit width but different slit separations). Sketch the two
side-by-side patterns roughly to scale.

➃

Rotate the slit disk to the next comparison set (2 double slits with
the same slit separation but different slit widths). Sketch the two
side-by-side patterns roughly to scale.

➄

Rotate the slit disk to the next comparison set (double slits/triple
slits with the same slit separation and same slit widths). Sketch the
two side-by-side patterns roughly to scale.

➅

Replace the Multiple Slit Set with the Single Slit Set. Select the
line/slit comparison. Sketch the two side-by-side patterns roughly
to scale.

➆

Select the dot pattern, and sketch the resulting diffraction pattern
roughly to scale.

➇

Select the hole pattern, and sketch the resulting diffraction pattern
roughly to scale.

Questions

➀

What are the similarities and differences between the single slit
and the double slit?

➁

How does the double slit pattern change when the slit
separation is increased?

➂

How does the double slit pattern change when the slit width is
increased?

➃

What differences are there between a double slit pattern and a
triple slit pattern?

Advertising