ADC Soneplex P-61-743 - Manual (Page 28)

ADCP-61-743
• Issue 3 • September 2004
Page 28
 2004, ADC Telecommunications, Inc.
DS3 MUX
RTAU
A
B
A
B
EQUIPMENT (E)
[NETWORK]
FACILITY (F)
[CUSTOMER]
CIRCUIT
UNDER TEST
SIGNAL
PRESENCE
DETECTOR
DS3 MUX
RTAU
EQUIPMENT (E)
[NETWORK]
FACILITY (F)
[CUSTOMER]
CIRCUIT
UNDER TEST
SIGNAL
PRESENCE
DETECTOR
11872-B
QRS
LOOPE LOOPF
QRS
Figure 16. LOOPF and LOOPE
RTAU SETUP AND CONTROL
EQUIPMENT SETUP
===============
Current User : CRAFT Test Circuit: 1-2
Line Code : INTERNAL Mode : SPLTE
SIGNAL GENERATOR SETUP
======================
Pattern Type : QRS #: --------------------------------
Frame Format : ESF
Loop Code : NONE #: ----------------
BIT ERROR SETUP Error Counts Status Elapsed Time
=============== ============ ====== ============
Error Count : 0 Data : F Sync: * ES :
Error Rate : OFF BPV : P Sync: * EFS:
Error Locn : N/A Frame: RAI :
CRC:
COFA
Test Timeout : 60 Measurement : START WAITING ON SYNC
In Minutes
Press CONTROL-A For Assistance
Figure 17. RTAU Setup and Control Screen (Starting a Measurement)
6 TL1 COMMANDS
The TL1 commands shown in Table 4 that are used for the RTAU are defined in Bellcore
requirement GR-000834-CORE. For more information about TL1 commands, refer to the
Soneplex System Operation and Maintenance Manual listed under Related Publications at the
beginning of this manual.