Bosch TCC78K751 Edelstahl Kaffeevollautomat - Manual (Page 58)

56 | English
Bosch TCC78K751 | 11/2011
To start without the prompt (see “Displaying
Settings”) press and hold down k (9) for at
least three seconds and select
Descaling program Start with O
Press o start/stop (10). The display will
guide you through the programme.
Empty drip tray
Empty the drip tray (22).
Replace drip tray
Replace the drip tray.
If the milk frother is not inserted,
the following message is displayed:
Set up milk frother
Insert the milk frother (12)
Place container under milk frother
Press O
Place a container with a capacity of
0.5 litres under the milk frother (12).
Press o start/stop (10).
The coffee grounds container (28)
can also be used. To avoid splut-
tering, push the coffee outlet (11)
down fully.
If the water ilter is activated, the
following message is displayed:
Remove filter
Press O
Remove the water ilter and press o start/
stop (10).
Add 0.5 l water and descaler
Press O
Pour lukewarm water into the empty water
tank (14) up to the calc (0.5 litre) mark and
dissolve two descaling tablets in it. Press
o start/stop (10). The descaling pro-
gramme now runs for about 24 minutes:
Descaling
If there is not enough descaling
luid in the water tank, the following
message is displayed:
Not enough descaling fluid
Refill fluid Press O
Pour lukewarm water into the empty water
tank (14) up to the calc (0.5 litre) mark
and dissolve two descaling tablets in it.
Press o start/stop (10). The descaling
programme will continue.
Clean and refill water tank
Press O
Rinse the water tank and reill it with fresh
water up to the “max” mark.
Press o start/stop (10). The descaling pro-
gramme will now run for about 1 minute:
Descaling
Empty drip tray
Empty the drip tray.
Replace drip tray
Replace the drip tray.
Replace the ilter if one is being used.
The appliance is ready for use again.
Important: Wipe down the appli-
ance using a soft, damp cloth to
immediately remove any descaler
residue. Such residue can cause
corrosion. New sponge cloths may
contain salts. Salts can cause rust
ilm on stainless steel and must
therefore be washed out thoroughly
before use.
TCC78K751_Heft1.indb 56 15.11.2011 10:15:23