Bosch TES50251DE VeroCafe Kaffeevollautomat silber - Manual (Page 30)

26
Robert Bosch Hausgeräte GmbH
26 en
Display messages
The display (15) shows not only the current
operating status, but also various messages
that give you status information or let you
know when you need to take action. As
soon as you have taken the necessary
action, the message disappears and the
menu for drink selection is displayed again.
Before using for the
first time
General
Fill the appropriate container using only
pure, cold, uncarbonated water and only
roasted beans (preferably espresso or
coffee bean blends for fully automatic coffee
machines). Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory default setting
for the water hardness is 4. Check the
water hardness with the enclosed test strip.
If the check reveals a value other than
4, change the setting on the appliance
accordingly after switching on (see “Menu
settings” Water hardness ).
Switching on the appliance
1. Remove the protective film.
2. Place the fully automatic espresso
machine on a flat, water­resistant
surface that can take its weight. Make
sure that the machine’s ventilation slots
remain unobstructured.
Important: Only use the appliance in
frost-free rooms. If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation.
3. Pull the power cord out of the storage
compartment (20) and plug in. Adjust
the length of the cable by pushing it
back in or pulling it out. The easiest way
to do this is to place the appliance so
that its back is flush with the edge of the
counter and either pull the cable down-
ward or push it upward.
4. Install the milk frother. Operate the
machine only after the milk frother (6)
has been fully assembled and installed.
5. Lift the lid of the water tank (17).
6. Remove and rinse the water tank (16)
and fill it with fresh cold water.
Do not fill above the max mark.
7. Replace the water tank (16) and push it
firmly downward into place.
8. Close the lid of the water tank (17)
again.
9. Fill the bean container (1) with coffee
beans. For preparation using ground
coffee, see “Preparation using
ground coffee”.
10. Press the power switch O / I (9).
The display (15) shows the menu for
setting the display language.
11. Select the required display language
with the upper rotary knob (14). The
following languages are available:
Deutsch
English
Français
Italiano
12. Press the start button (10). The
language you selected is saved. The
display shows Pull milk frother .
13. Place a receptacle under outlet.