Bosch TES50251DE VeroCafe Kaffeevollautomat silber - Manual (Page 41)

37
TES502.. | 02/2014
37 en
N.B.: If the water filter is activated, the
display will prompt you to remove the filter
and then press the start button (10) again.
Remove the filter now if you have not
already done so.
Press the start button (10).
Fill descaler
Press start
● Pour lukewarm water into the empty
water tank (16) up to the 0.5 l mark and
then dissolve 1 Bosch descaling tablet
TCZ8002 in it. When using TCZ6002,
2 tablets must be dissolved.
● Press the start button (10).
Calc‘n‘Clean in progress
The descaling pro gramme will now run for
about 10 minutes.
Place container
Pull milk frother
● Place a receptacle with a capacity of at
least 1 litre under the outlet (6c).
● Pull the milk frother (6) to open it.
Calc‘n‘Clean in progress
The descaling pro gramme will now run for
about 12 minutes.
Clean / Fill water tank
Press start
● Rinse the water tank (16) and refill it with
fresh water up to the max mark.
● Press the start button (10).
Calc‘n‘Clean in progress
The descaling pro gramme now runs for
about 30 seconds and rinses the appliance.
Push milk frother
● Push the milk frother (6) in to close it.
Calc‘n‘Clean in progress
The cleaning pro gramme will now run for
about 8 minutes.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Replace the filter if one is being used. The
appliance has finished cleaning is ready for
use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use.
Frost protection
¡
To avoid damage from low
temperatures during transport
and storage, the appliance must
be completely emptied first.
Note: The appliance must be ready for use
and the water tank (16) filled.
1. Place a large receptacle under outlet (6c).
2. Press the h button (11).
The h button (11) flashes and the
appliance now heats up for approx.
20 seconds. The display then shows
Pull milk frother .
3. Open the milk frother (6) by pulling it out
and release steam for about 15 seconds.
4. Switch the appliance off at the power
on/off switch O / I (9).
5. Empty the water tank (16) and the drip
tray (8).