Bosch TES50251DE VeroCafe Kaffeevollautomat silber - Manual (Page 31)

27
TES502.. | 02/2014
27 en
14. Carefully pull out the milk frother (6) to
open it. The appliance rinses out the
milk frother (6) with water. The display
shows Push milk frother .
15. Push the milk frother (6) in to close it.
The appliance heats up and rinses. Some
water will run out of the coffee outlet.
When the drink selection menu is shown in
the display, the appliance is ready for use.
Switching off the appliance
The factory settings of the fully automatic
espresso machine are programmed for
optimal performance. The appliance
switches off automatically after a specific
time (time span can be programmed, see
“Menu settings” Shut off ).
Exception: The appliance switches off
without rinsing if only hot water or steam
were dispensed.
To switch the appliance off manually
before this, press the
e
off / j button (12).
The appliance rinses and switches off.
N.B.: If the appliance is being used for the
first time, a service program has been run,
or the appliance has not been operated
for a long period, the first beverage will
not have the full aroma and should not be
consumed.
When using the espresso machine for the
first time, you will achieve a suitably thick
and stable “crema” only after the first few
cups have been dispensed.
After extended use, water droplets may
form on the ventilation slots. This is normal.
Water filter
A water filter can prevent scale buildup.
Before a new water filter is used, it must be
rinsed. To do this, proceed as follows:
1. Press the water filter firmly into the
water tank with the aid of the measuring
spoon (18).
2. Fill the water tank (16) with water up to
the max mark.
3. Press and hold the
e
off / j button (12)
for at least three seconds. The menu
opens.
4. Press the
e
off / j button (12)
repeatedly until the display shows
No / Old filter .
5. Select Activate filter with the upper
rotary knob (14).
6. Press the start button (10).
7. Place a receptacle with a capacity of
0.5 litres under the outlet.
8. Press the start button (10).
9. Pull the milk frother (6) to open it.
10. Water will now flow through the filter to
rinse it.
11. Push the milk frother (6) in to close it.
12. Empty the container.
The appliance is ready to use once more.
Note: Rinsing the filter simultaneously
activates the setting for the Change filter!
display.