Bosch TES50251DE VeroCafe Kaffeevollautomat silber User Manual

Page 44

Advertising
background image

40

Robert Bosch Hausgeräte GmbH

40

en

Problem

Cause

Solution

Display shows

Check water tank

Water tank has been

incorrectly inserted or the

new water filter has not

been rinsed according to

instructions.

Insert the water tank correctly or

rinse the water filter according to

instructions and then switch on.

Carbonated water in the

water tank.

Fill the water tank with fresh tap

water.

The coffee grounds are

not compact and are too

wet.

The grinding setting is too

fine or too coarse, or not

enough ground coffee has

been used.

Adjust the grinding unit to a

coarser or finer setting, or use

2 level measuring spoons of

ground coffee.

Display shows

Clean brewing unit

Brewing unit (5) is soiled.

Clean brewing unit (5).

Too much pre-ground

coffee in the brewing unit

(5).

Clean brewing unit (5)

pour in no more than 2 level

measuring spoons of ground

coffee.

The brewing unit’s

mechanism is stiff.

Remove and clean the brewing

unit, see “Maintenance and daily

cleaning”.

Coffee or milk froth quality

varies considerably.

Build-up of limescale in the

appliance.

Descale the appliance as

described in the instructions.

Water dripped onto the

inner floor of the appliance

when the drip tray (8) was

removed.

Drip tray (8) removed too

early.

Wait a few seconds after the

last drink was dispensed before

removing the drip tray (8).

Display shows

Insert brewing unit

Brewing unit (5) is missing

or was not recognised.

Switch off the appliance with the

brewing unit (5) in place, wait

three seconds and switch on the

appliance.

Restore the unit to its

original factory settings

(“Reset”).

You changed some settings

and want to discard them.

Turn off the unit with the power

on/off switch

O / I (9). Press

and hold the

e

off /

j

(12) and

the

h

(11) button and turn the

appliance on with the power

on/off switch

O / I (9). Confirm by

pressing the start button

start

(10). The factory settings are now

activated.

If you are unable to solve the problem, always call the hotline!

You will find the telephone numbers at the back of these instructions.

Advertising