Teledyne 3000ZA2G - Zirconium oxide analyzer - Manual (Page 27)

Trace Oxygen Analyzer Installation
Teledyne Analytical Instruments 15
Installation
Installation of the Model 3000ZA2G Analyzer includes:
1. Unpacking
2. Mounting
3. Gas connections
4. Electrical connections
5. Installing the sensor
6. Testing the system.
3.1 Unpacking the Analyzer
The analyzer is shipped with all the materials you need to install
and prepare the system for operation. Carefully unpack the analyzer and
inspect it for damage. Immediately report any damage to the shipping
agent.
3.2 Mounting the Analyzer
The Model 3000ZA2G is for indoor use in a general purpose area.
It is NOT for hazardous environments of any type.
The standard model is designed for 19” rack mounting. Figure 3-1 is
an illustration of the 3000ZA2G.
Figure 3-1: Model 3000ZA2G
All operator controls, except the flow control needle valve, are
mounted on the control panel, which is hinged on the left edge and
doubles as the door that provides access to the sensor and connections