Teledyne 7600 - Infrared gas analyzer - operating manual User Manual

Page 33

Advertising
background image

Infrared Gas Analyzer

Installation

Teledyne

Analytical

Instruments

33

Figure 2-10: Noise Suppression

2.6.2 Input/Output Terminal Module

Use the supplied cable to interface the I/O Module to the analyzer.
Plug the cable connector into the receptacle at the rear panel of the

analyzer and the receptacle on the PC board of the input/output module.

Make sure that the ferrite core attached to the I/O cable goes to the

analyzer. See Figures 2-9 and 2-11.

Figure 2-11: I/O Cable Connection

The I/O Module carries various input and output signals. A detailed

list of these signals and pinout information is given in the Appendix.

Advertising