Teledyne 7600 - Infrared gas analyzer - operating manual - Manual (Page 42)

Operation Model 7600
Teledyne Analytical Instruments 42
• Set up the Auto Calibration feature
• Setup an auto zero calibration
• Adjust the peak alarm parameter Setting.
These settings are described in Section 3.5.
To enter the user mode from the measurement mode, press the
MODE key. To return to the measurement mode, press the MODE key
again or ESC.
3.5 Setting Up the Analyzer in the User Mode
3.5.1 Switch Ranges
From the Switch Ranges menu you can:
a. Manually select a desired range for any channel.
b. Use the remote range switch contacts to select a range.
c. Select autoranging.
To enter the Switch Ranges menu:
1. Press the MODE key to enter the user mode.