Victory HIA-1D-S7-XH - Manual (Page 12)

SECTION 2
INSTALLATION
A. Receiving Shipment
Upon arrival, examine the exterior of the shipping carton
for any signs of rough handling. It is advisable that the
shipping carton be partially removed, in order to examine
for any possible concealed damages which might have
occurred during shipment.
If no damages are evident, replace shipping carton by
restapling or nailing to skid in order to protect the cabinet
during local delivery. If the cabinet is damaged, it should
be noted on the delivery slip or bill of lading and signed
to that effect. A claim must be filed immediately against
the carrier indicating extent and estimated cost of
damage incurred.
All units are performance tested and thoroughly
inspected prior to shipment. Upon leaving the factory, all
units are in perfect condition and the carrier signs to this
effect.
B. Uncrating Procedure
WARNING
DO NOT , Under Any Circumstances,
Lay Your New Equipment Down On
Either The Back, Front or Sides
See instructions printed on shipping carton. Remove top
cap and cardboard side walls. Remove wooden skid.
The shipping skid must be removed by tipping the model
from side to side. Remove the shipping bolts while the
model held in one direction, then repeating this
procedure when the model is held in the opposite
direction.
C. Reducing Warmer Depth For Narrow Facility
Doorway
In order to pass through a narrow doorway or restricted
area, the following may be removed to reduce the overall
depth of the cabinet to a minimum of 32-1/2” deep:
1. Removing Doors. (Refer to Figure 2-1)
a. Open door to approximately 90
°
b. Lift door straight up and off hinges
Figure 2-1
Door Removal
2. Front Grille
a. On grilles with dial thermometers or electrical
components, disconnect capillary tubing and/or
e l e c t r i c a l c o n n e c t i o n s b e f o r e c o m p l e t e l y
removing air grille.
Note: The thermometer capillary tube and sensing bulb
are attached to cabinet. If the grille has to be removed,
caution must be taken when removing the capillary tube.
b. Remove the front air grille by removing the two
(2) sheet metal screws on the inside of the grille
at each end. Push up at the bottom of the grille
to disengage the rivets from the keyhole slots
and pull forward.
SECTION 2-INSTALLATION SECTION 2-INSTALLATION
8