Victory HIA-1D-S7-XH - Manual (Page 14)

Tilt the cabinet in one direction approximately eight
inches and block it securely to keep it from falling. Use
several pieces of 2” x 4” lumber or other suitable material.
Screw the two left right legs in until snug with brace.
Repeat this procedure to install the other legs.
WARNING
DO NOT , Under Any Circumstances,
Lay Your New Equipment Down On
Either The Back, Front or Sides
F. Leveling
Cabinet must be leveled when installed. This is
accomplished by rotating the foot of the leg with an
adjustable wrench. Failure to level your cabinet may
result in doors not sealing, closing properly or
condensate water not draining properly.
G. Initial Cabinet Set-Up
Units are shipped with shelves or pan slides. These
items are secured to the rear of the cabinet directly on
the wood skid. Two (2) keys are supplied per unit and
are taped to the door handle. An additional key is taped
to the top of the air grille.
1. Cleaning Cabinet
CAUTION:
DO NOT Use Volatile Cleaning Solvents!
Never scour any part of your new cabinet. Scouring
powders or chemicals may cause damage by scratching
or dulling the surface finish. Prior to placing your new
warmer and all shelves, pans and slides into operation, it
is advisable that the interior be washed thoroughly with a
mild detergent and water solution. Rinse with clear water
and a sanitizing solution. Allow cabinet to dry.
2. Installing Shelves
All models with shelves are supplied with pilasters and
shelf clip supports. The pilasters have 3/8” square
openings on 1” centers. Shelves are easily installed by
inserting the shelf support clips into the pilasters. Insert
the clips as shown in Figure 2-4. The clips fit tightly so it
may be necessary to push the clips into their holes. Align
the shelf so that the smaller fill wires run from front to rear
and rest on the shelf clips.
Figure 2-4
Installing Shelf Clip Supports Into Pilasters
3. Pan Slides (Optional)
a.
Stainless Steel Angle Type Pan Slides.
(Refer to Figures 2-5 & 2-6)
Cabinets may be supplied with removable stainless steel
angle pan slides, and are available in the following:
● Type “A” for one 18” x 26” pan or two 14” x 18”
pans Bottom Support
● Type “B” for one 18” x 26” pan or two 14” x 18”
pans Lip Support
● Type “C” for 12” x 20” pans, Lip Support
● Type “A/C” for one 18” x 26” pan, 12” x 20” pans
or two 14” x 18” pans, Bottom Support
SECTION 2-INSTALLATION SECTION 2-INSTALLATION
10