Victory HIA-1D-S7-XH - Manual (Page 13)

3. Hinges and Lock Keeper
a. Refer to Figure 2-2. To remove the hinge base
from the cabinet fascia, unscrew the three
machine screws.
On the upper hinge, you will notice a light switch with six
inch red lead wires. Tape switch to interior door jamb.
Do not remove wires.
When reinstalling upper hinge, nest switch into bottom of
base and fasten carefully to fascia.
Figure 2-2
Hinge and Light Switch
b. To remove lock keeper (“D” shaped metal casting
for lock bolt) use a 5/16” open end wrench.
Remove the two #10-32 screws attaching keeper
to fascia. Reverse procedure to reinstall. Refer
to Figure 2-3.
Figure 2-3
Lock Keeper
D. Locating Your New Warmer
The following conditions should be considered when
selecting a location for your warmer:
1. Clearance - There must be a minimum clearance of
10” between the top of the warmer and the ceiling of
the room.
2. Floor Load - The floor on which the cabinet will rest
must be free of vibration and suitably strong enough
to support the combined weights of the cabinet plus
the maximum product load which might be placed
into it. To estimate the possible product load weight,
it is generally conceded that a safe figure is 35
pounds for each net cubic foot of storage space. For
example, a 47 cubic foot cabinet could hold
approximately 1,645 pounds of product (47 x 35 =
1,645).
3. Ventilation - Vent assemblies are supplied with
each cabinet to assist in the warming process of
foods. The vent knob is located inside the warmer
cabinet at the top. By turning the knob left or right,
moisture within the cabinet can be controlled.
E. Installing Legs or Casters
Warmers are shipped with legs or casters. Legs and
casters are the 1/2” single stud mount type and require
no tools for installation. Simply screw them into the
threaded holes located in the braces on the case bottom.
SECTION 2-INSTALLATION SECTION 2-INSTALLATION
9