Victory HIA-1D-S7-XH User Manual
Page 23
G. Special Feature Shims for Hinged Door Adjustments:
There are a couple of special feature shims that assist with the adjustment of hinged doors using the self-closing hinge
assembly (pn 10685101). These items can be used as a second or third option if additional adjustment is required.
Refer to the shim descriptions below and their purpose.
1.
Fascia Shim (pn 05072701) - The fascia shim is used to help extend the “Hinge Bracket” (pn 50520103)
in a forward direction when the door gasket needs to be loosened from or accurately tightened to the
cabinet fascia.
When using this shim, build-up the hinge bracket by inserting one at a time until the forward extension
supports an acceptable gasket seal to the cabinet. Hinge bracket adjustments can be different from door
to door.
Make sure that the open end of the slot shaped cut -out is always facing towards the door with the hinge
switch assembly wires going through it. If the wires are not put through the slot shaped cut-out, there could
be a great possibility of wire damage to the hinge switch assembly.
2.
Leveling Shim (pn 50538601) - The leveling shim is used to raise the door in an up or down direction. This
part is placed behind the the hinge barrel (pn 50520102) with the open ends of the three slot shaped cut-
out’s facing towards the cabinet. While adjusting the top or bottom screws per hinge barrel, the door will go
in a specific direction. Check out the following information below and refer to page 18 for pictures.
a.) Top Hinge Barrel with Leveling Shim - Adjusts the door in a downward direction.
b.) Bottom Hinge Barrel with Leveling Shim - Adjusts the the door in an upward direction.
*Note: When inserting and/or adjusting the leveling shim, avoid taking the screws completely out of the door.
Try to make a gap wide enough to slip the shim in between the hinge barrel and the door, then tighten
the screws until the leveling process of the door is satisfactory and stable.
SECTION 3-OPERATION
SECTION 3-OPERATION