AT&T CL83301 - Manual (Page 50)

Multiple handset use
44
Push-to-talk (PTT)
Using the telephone base:
1. There are a few ways to begin a PTT call to a single
handset. When the telephone base is not in use:
If you have one handset, press and hold �TT.
If you have more than one handset:
w Press �TT. Then use the dialing keys to enter the
destination handset number.
-OR-
w Press q
CID
or p
DIR
to highlight the destination
handset number. Then press
MENU
/�ELECT or �TT.
The telephone base shows Connecting to HAND�ET X...
( HAND�ET represents the handset name, X represents
the destination handset number) for a few seconds. When
the connection is made, both the telephone base and
destination handset display
�ress and hold [�TT] to talk.
2. Press and hold �TT. A chirp indicates your microphone
is on.
Speak towards the telephone base. Your voice is broadcast to the
destination handset.
While you are speaking, the telephone base shows
�TT To handset: X.
3. Release �TT after speaking. Both devices beep once again and the screens
show �ress and hold [�TT] to talk. Then you can press and hold �TT to
continue speaking or the destination device can respond (see
Answer a �TT call on page 46).
4. To end the PTT call, press CANCEL. The telephone base shows
�ush to talk Ended for a few seconds.
•
•
PTT To
handset: X
PUSH TO TALK
>Handset X
p
q
Connecting to
Handset X...
p
q
Press and hold
[PTT] to talk