Ransburg RMA Direct A12867 - Manual (Page 14)

RMA-303 Direct Charge - Introduction
11 LN-9266-11.3
SPECIFICATIONS - Electrical / Mechanical
Electrical
Power Supply Type: MicroPak
Charging Method: Direct
Output Voltage: 0-100 kV Variable
Output Current: 125 µA
Turbine Speed Control: Atomizer Module
Part Spray ability: Determine spray ability of part to be coated using Test Equip -
ment (76652) (Paint Conductivity Meter)
Mechanical
Length: . (See RMA-303 Tool Point, Center of Gravity, and Envelope
Dimen sions (Single and Dual Flex) figure in the “Introduction”
section.)
Diameter: (See RMA-303 Tool Point, Center of Gravity, and Envelope
Dimen sions (Single and Dual Flex) figure in the “Introduction”
section.)
Approximate Weight
Atomizer Only: 17.3 lbs. (7.83 Kg) max.
Total Payload with Robot
Plate & Adapter:
20.1 lbs. (9.12 Kg) max.
Turbine Type: Air Bearing Impulse Drive
Turbine Air Supply: Variable (See “Pressure Flow Data Charts” in the
“Introduction” section.)
Maximum/Minimum
Turbine Speed:
Continuous 70K rpm max./20K rpm min.
Maximum Angular Velocity
for Turbine (Robot Motion):
250 ° /sec.
Tubing Bundle Max.
Rotation:
450 ° in Either Direction
Bearing Air Supply
at the Applicator:
90 psig (±10 psi)
Nominal): (621 kPa ±69 kPa) 2.9 SCFM (82 slpm)
Shaping Air #1 (SAI) Supply: Variable (See “Pressure Flow Data Charts” in the
“Introduction” section.)