Ransburg Discrete IO Module A11435 - Manual (Page 12)

Analog Inputs
0-10 VDC or 4-20 mA set by position 8 of SW2. In 0 to 10 VDC mode (SW2-8 down), input impedance
is 150 kohm. In 4 to 20 mA mode (SW2-8 up), input impedance is 500 ohm.
Analog Outputs
(3 mA maximum for 0-10 VDC outputs, 20 VDC maximum for 4-20 mA outputs)
The four analog outputs in this table are individually settable for either 0-10 VDC or 4-20 mA outputs.
the Down position of the Mode Control switch is for 0-10 VDC. The Up position is for 4-20 mA.
High Voltage Output Level, 0-100 kV
High Voltage Output Ground
Current Output Level (See "Figure 1 - Required
Dipswitch Setting" for scaling)
Current Output Ground
Atomizer Speed Feedback (See "Figure 1 -
Required Dipswitch Setting" for scaling)
Speed Feedback Ground
Drive Pressure Feedback, 0-100 psi
Drive Pressure Ground
TABLE 2 - ANALOG OUTPUTS
GRN
BLA
WH
BLA
RED
BLA
BLA/RED
BLA
Wire Color Description
14C
17A
6C
8A
7C
7A
8C
7A
Pin #
Mode
Control
SW6
SW5
SW3
SW4
High Voltage Setpoint, 0-100 kV
High Voltage Set Ground
Overcurrent Setpoint (See "Figure 1 - Required
Dipswitch Setting" for scaling)
Overcurrent Setpoint Ground
Speed Setpoint, 0-50 or 0-100 krpm
Speed Setpoint Ground
Di/Dt Sensitivity 0-9 Scale (0 is most sensitive)
Di/Dt Sensitivity Ground
TABLE 1 - ANALOG INPUTS
YEL
BLA
BLU
BLA
BRN
BLA
WHT
BLA
Wire Color Description
5A
28C
6A
28A
4C
3A
3C
28A
Pin #
Discrete I/O Module - Safety
9 LN-9253-06.1
Ransburg