Ransburg Overhead Electric Reciprocator ER-8100 - Manual (Page 15)

MAIN MENU
The MAIN MENU screen is used to access all
other sub-menus. From the main menu, other
menus are accessed using the function keys. The
list of sub-menus may be viwed using the up and
down arrow keys. It is not, however, necessary
to have the required sub-menu in view to select
it. Throughout the entire menu structure, the F12
function key is used to return to the main menu.
OPERATION
RUN MODE
The menu for RUN MODE is selected from the
MAIN MENU using the F1 key. The selections
under Run Mode determine the type of Program
which will be run. A Program is a sequence of
points and associated velocities, digital outputs
(2), and analog outputs (1). A program may
have from two to eight points. Shown below is
a description of a program with four points. The
program is run by the reciprocator in the forward
direction (Point 1 to 2 to 3 to 4) at the velocity
specified at the start of a segment. The digital
and analog outputs are also set as specified at
the starting point of the segment. At the last point
the sequence is reversed. The program is run in
the reverse direction (Point 4 to 3 to 2 to 1). In
order to maintain the same velocity, and digital
and analog outputs, while running in the reverse
direction, the values from the end point of each
segment must be used for that segment.
Point 1: 7” @ 30”/sec Dig1:0 Dig2:0 Analog: 0
Point 2: 35” @ 15”/sec Dig1:1 Dig2:0 Analog: 60
Point 3: 50” @ 30”/sec Dig1:1 Dig2:0 Analog: 0
Point 4: 97” @ 30”/sec Dig1:1 Dig2:0 Analog: 0
Point 5: 0”
12
Electric Overhead Reciprocator - Operation
Ransburg
LN-9801-05.1