Securitron M680 - Manual (Page 6)

PN# 500-10550
Page 6 Rev. C, 08/12
Magnalock Installation
1.
C
H
1 Remove three (3) screws securing lock to mounting
bracket and slide the bracket from the top of the
lock chassis.
2.
Pinch and insert spacers flush into the dovetail slots of
the lock-mounting bracket.
3. Mark Mounting Holes:
Use masking tape to protect the door and frame surfaces during marking and drilling.
Place the lock bracket on the secure side of the door against the frame stop toward the side
of the door that does not have hinges. Close the door and adjust the bracket so that the
spacers rest against the door. Mark the frame through the two (2) oblong bracket mounting holes.
Note: Maintain 7/8” minimum clearance from the frame
4. Mark Wire Feed-Through Holes:
Mark the frame for wire feed-through hole at the end closest to where you will access the wire run.
These holes should be toward the rear edge of the mounting bracket and be adjacent to the end of
the bracket as shown. Remove mounting bracket from frame when drilling holes.
Use either location for Wire Feed-Through Holes
Quick Clip 2:
Mounting the
Bracket