Securitron M680 - Manual (Page 9)

PN# 500-10550
Page 9 Rev. C, 08/12
Bracket Spacers
Strike Installation
1.
Close the door and place the template between the bracket spacers.
Mark the strike plate hole locations.
Bracket spacers can now be removed from the bracket.
2. From INSIDE the door:
Drill one (1) 3/8” diameter hole for the
sex bolt through the door at the strike
mounting center mark.
Drill two (2) 3/8” diameter x 1” deep
holes at each side mark for the strike
alignment roll pins. Do not drill through
the door.
3. From OUTSIDE the door:
For a Hollow Metal Door: Drill out the 3/8”
diameter strike mounting hole to 1/2”
diameter in the outer wall only.
For a Solid Wood Door: Drill out 3/8”
diameter strike mounting hole to 1/2”
diameter; drill completely through.
Quick Clip 4:
Strike
Installation
Quick Clip 5:
Door
Drilling