Securitron M82B - Manual (Page 2)

PN# 500-10420
Page 2
Rev. F, 02/11
4. RECOMMENDED TOOLS
Power Drill Hammer Wire Strippers/Cutter
1/8”, 3/8”, 1/2” Drill Bits Center Punch Crimp Wire Connectors
1/2” Open end or Crescent Wrench Masking Tape Crimp Tool
3/16” Hex Key (Allen Wrench) Fish Tape or Lead Wire Multimeter
5. INSTALLATION INSTRUCTIONS
5.1 Pre-Installation Survey
It is recommended that an initial on sight survey be performed. A method of mounting should
be determined and an installation plan should be reviewed as follows:
 Physical strength of mounting areas should be strong enough to meet or exceed the
holding force of the required Magnalock.
 Placement of the Magnalock wiring and protection from potential damage due to intruders
or vandals external attack should be considered during the survey.
 Accessibility should be considered for prevention of any potential safety hazard.
Additional brackets may be needed for proper installation. Specialized brackets are available
through Securitron and their many product distributors. (Section 6)
5.2 Out-Swinging Door
The installation shown below in Figure 2 illustrates the door swinging away from the Magnalock.
This is a common configuration on the secure side of exit doors. The Magnalock mounts to the
door frame header near the corner opposite the hinge side. The Magnalock may be mounted
horizontally or vertically depending on the installation required. The brackets shown in Figure 2
are to assist installation to door frames that may need modifications to complete the installation.
Figure 2
Dress Plugs
Mounting Screws
Sex Bolt & Strike
Mounting Screw
Door Frame & Stop
Rubber Washers
Door
Strike Plate
Flat Washers
Blind Nuts
Magnalock
UHB Bracket
SFP Bracket
M32 ~ 2-1/4”
M62 ~ 2-1/2”
M82 ~ 2-1/2”