Securitron SAM - Manual (Page 13)

PN# 500-10440
Page 13 Rev. F, 02/12
8 MAGNALOCK MAINTENANCE
8.1 Visual Inspection
 Check the strike assembly for proper gap, suspension and free movement. Tighten strike
adjustment screws as required.
 Check for build-up of debris on the Magnalock and strike armature. Clean as required.
 Check for rust on the Magnalock and strike assembly. Clean as required.
8.2 Cleaning Methods
 Cleaning once a year is recommended.
 Clean every six months where minor rusting occurs.
 Clean every three months if rust conditions are severe.
 Use a plastic dishwashing scrub pad to aid in the removal of rust.
DO NOT USE PETROLEUM BASED PRODUCTS FOR CLEANING
DO NOT USE STEEL WOOL BASED SCRUB PAD OR SANDPAPER
8.2.1 Indoor Applications
 Apply rubbing alcohol onto a clean cloth and thoroughly wipe down the Magnalock and
strike plate armature.
8.2.2 Outdoor Applications
 Apply a silicone based cleaner/lubricant onto a clean cloth and thoroughly wipe down
Magnalock and strike plate armature.
Example: Super Lube® Aerosol with SYNCOLON® (PTFE)
Part No.: 31040 ~ 6oz. / 31110 ~ 11 oz. / 32015 ~ 14 oz.
Phone: (631) 567-5300 / Website: www.super-lube.com
APPENDIX A
Troubleshooting
Problem Lock Does Not Generate a Magnetic Field Points of Reference
Check for specified voltage at Magnalock Section 2
Solution
Check for specified current draw at Magnalock Section 2
Problem Reduced Holding Force Points of Reference
Check DC power source is Full-Wave Rectified
(Half-wave Rectifier or AC Power unacceptable)
Section 6.2
Check for specified voltage at Magnalock Section 2
Check for specified current draw at Magnalock Section 2
Check strike mounting for proper installation Sections 5.6-5.7
Solution
Check the Magnalock and strike for obstructions
and that contact surfaces are properly cleaned
Section 8
Problem BondSTAT Does Not Report Secure Points of Reference
Check for specified voltage at Magnalock Section 2
Check for specified current draw at Magnalock Section 2
Check strike mounting for proper alignment and
pivoting for proper closure to Magnalock
Table A / Section 5.6.6
Solution
Check the Magnalock and strike for obstructions
and that contact surfaces are properly cleaned
Section 8