Securitron DKC - Manual (Page 18)

PN# 500-33510
Page 18 Rev. A, 06/13
Command Function
70*
Turns on the double beeper chirp that sounds when the relay is
energized by a valid code or REX (not used in toggle or passage
modes)
71* Turns off the double beeper chirp (default)
72* Turns on the key press single beeper chirp (default)
73* Turns off the key press single beeper chirp
74*
Reverses light logic (red to echo key presses and green to show relay
is energized)
75*
Returns light logic to factory setting (green to echo key presses and
red to show relay is energized)
76*
Duress option turned on. Use of hard code releases door and trips one
of the three option relays. Note that one of the three option relays
must be setup for this function; see code 78*
77* Duress option turned off (default)
78*
Program option relay. By default there are no functions assigned to
any of the three relays. Follow the command by the relay number (1,
2, or 3) followed by one of the function numbers listed below:
1 = Alarm Shunt
2 = Camera Call-Up
3 = Door Prop
4 = Keypad Tamper
5 = Duress
6 = Door Bell
7 = Forced Entry
79*
Delete a User code. Any valid user code entered will be deleted. Press
the # key twice to complete the deletion.
80*
Anti-tailgating option turned on. When the door position switch closes
the lock re-secures regardless of the status of the relay timer.
81* Anti-tailgating option turned off (default)
82*
Door bell button assigned to the # key (default). Note that one of the
three option relays must be setup for this function; see code 78*
83*
Door bell button assigned to the * key. Note that one of the three
option relays must be setup for this function; see code 78*
84*
Set real time clock in “US” mode. Follow the command by mm dd yy
hh mm (month, day, year, hour, minute). Enter hours in 24-hour
time format (i.e. 12am = 00, 9am = 09, 12pm = 12, and 9pm = 21).
85*
Set real time clock in “International” mode. Follow the command by
dd mm yy hh mm (day, month, year, hour, minute). Enter hours in
24-hour time format (i.e. 12am = 00, 9am = 09, 12pm = 12, and
9pm = 21).
86*
Erase all User codes in the database. Press the # key twice to
complete the erasure. The yellow LED on continuously indicates that
there are no codes in the database.
87*
Followed by ‘00’ through ‘99’ sets the door prop timeout in seconds
(defaults to 5 seconds).
88*
Erase all codes except master, supervisor, and hard codes. Press the
# key twice to complete the erasure.
89*
Returns all functions (including timers) to factory default settings; all
codes are unchanged. Press the # key twice to complete factory reset.
9* Followed by ‘00*’ puts the relay in toggle mode
9*
Followed by ‘01’ through ‘99’ sets relay timeout in seconds (defaults to
5 seconds).