Securitron iMXDa_iEXDa_CH INSTALLATION - Manual (Page 2)

P/N 500-22155
Page 2 Rev. A, 11/12
5. INSTALLATION INSTRUCTIONS
Pre-Installation Survey
A site survey should be performed to determine the mounting location based on the following:
 Physical strength of mounting areas should meet or exceed the holding force of the
iMXDa/iEXDa.
 Routing of the lock wiring for protection from damage due to intrusion or vandalism.
 Door clearance should be considered to prevent a safety hazard.
Because of the lock system’s internal sensing, alignment between the lock face and strike are
vital for proper operation.
Additional brackets may be required for proper installation. (See Section 7 - Specialized
Mounting Brackets).
Mounting Configuration
Figure 2 illustrates a common installation on out-swing doors (IMXDa shown). The lock housing
mounts to the header near the corner opposite the door hinge side. The unit may be mounted
horizontally or vertically.
Figure 2
5.1. PHYSICAL INSTALLATION
Install the strike plate before installating the lock housing. Figure 3 illustrates typical strike
mounting for the iMXDa. (For the iEXDa the SB-MXD Sex Bolt, cap, and steel washer shown
here are replaced with a standard sex bolt).
Figure 3
The following tips are important for a successful install:
Strike Plate
1-3 Rubber
Washers
Roll
Pin
Strike Mounting
Screw
Strike Bushing
Door Frame
& Stop
Sex Bolt & Strike
Mounting Screw
Door Frame & Stop
Rubber Washers
Door
Strike Plate
Mounting Bracket
& Hardware
Lock Housing
SB-MXD Sex Bolt
(iMXDa)
Steel
Washer
Actuator
2X Actuator
Mounting Screws
& Dress Plugs
SB-MXD Cap
SFP (Not Included)
Standard Sex Bolt
(iEXDa)