SKC 228-9530 QuickTake 30 - Manual (Page 10)

9
Operation
Button Sequence
Butt ons must be pressed in the sequence
shown.
 or  = Press individually
[

] = Press both simultaneously

= Security code, press in sequence
Operating the Pump
• To activate LED:
Press and hold

for 2 seconds.
• To check battery status:
With the LED on, press

. If batt ery status is low, recharge the batt ery (see
Charging the Batt ery on page 6).
Battery Status Indicators
Full charge; approximately 75 to 100% batt ery capacity
remaining
Batt ery is charged enough to operate the pump;
approximately 25 to 75% batt ery capacity remaining.
Batt ery charge is low (charge batt ery); approximately
1 to 25% batt ery capacity remaining.
Low Batt ery Fault. Pump will stop running, beep, and
go to sleep in 10 seconds.