SKC 228-9530 QuickTake 30 - Manual (Page 21)

20
Programming Your Own Run Time Presets
1. Press

.
2. Pt: 1 will alternately display with T xx. This corresponds
to the fi rst stored preset time.
3. Press  to scroll to the number of minutes (1 to 999).
Press  to scroll to Cont, Intt , or End mode options. End
will not appear as an option during setup of the fi rst preset.
4. When the LED displays the desired time or mode, press

to move to the next preset time.
5. Repeat Steps 3 and 4 for each preset up to eight presets.
The sequence will repeat from one to eight.
6. When fi nished, press [

]. Stor will display on the
LED.
To save the new sett ings: Press [

]. The pump will
return to normal pump operation.
To ignore the new sett ings: Press

. The pump will
return to normal pump operation.
Note: While programming presets, scrolling below Intt will display End aft er
the fi rst preset is selected. Choosing End will truncate the stored preset sequence
(see below). For example, if the user desires to store only two presets, preset time
3 can be set to End, shortening the number of presets to scroll through. Times
programmed for preset times Pt: 4 through 8 will not display until the presets
are changed to make them display or the factory defaults are reset (see Resett ing
Pump to Manufacturer Default Sett ings).
Preset 8 End
Preset 7 Intt
Preset 6 Cont
Preset 5 t 15
Preset 4 t 10
Preset 3 t 5
Preset 2 t 2
Preset 1 t 1
Preset 8 End
Preset 7 Intt
Preset 6 Cont
Preset 5 t 1 - 999
Preset 4 End
Preset 3 t 1 - 999
Preset 2 t 1 - 999
Preset 1 t 1 - 999
Manufacturer Default Presets The pump returns to the beginning preset
at the fi rst End it encounters. This allows
the user to shorten the number of presets
to be scrolled through. Preset 1 cannot
be set to End.
Presets Sequence
5
Digital display:
Store settings
Digital display:
First preset
Digital Display:
Time set for preset 1