Gilderfluke&Co DMX-512 Output MultiShow Brick - Manual (Page 8)

the CPU. While performing an Ease-In, the heart rate will double.
F) Z-Brick: This twenty pin IDS connector is used to connect to one or more Z-Bricks. When en-
abled, the BR-MultiShow Bricks puts out data from the DMX-512 input or onboard Eprom to this
connector. The format of the data is as follows:
IDS pin # SIGNAL
1 Data bit 0
2 Data bit 1
3 Data bit 2
4 Data bit 3
5 Data bit 4
6 Data bit 5
7 Data bit 6
8 Data bit 7
9 Address bit 0
10 Address bit 1
11 Address bit 2
12 Address bit 3
13 Address bit 4
14 Address bit 5
15 Address bit 6
16 Address bit 7
17 ground
18 ground
19 Strobe/
20 Reset/
When the address and data lines are valid, the rising edge of the Strobe line will latch the
data into the addressed outputs.
G ILDERFLUKE & C O .¥ 205 S. F LOWER S T . ¥ B URBANK , CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥ FAX 818/840-9485
4 of 22