HTP FP-40SC - Manual (Page 18)

18
2. FRONT MOUNTS
Fully loosen the tilt hinge set screws. Once loosened, the tilt hinge will engage
into the Quick Lock frame rail. See Figure 5. Slide the flush mount to the
desired location along the bottom side of the collector that will meet the roof.
Tighten the screw to keep hinge from sliding. See Figure 3 for mounting
locations.
Next, attach the triangle foot to the tilt hinge with the 1 ¾” x 3/8” bolt,
4” x 3/8” bolt, and 3/8” nut and washer. See Figure 6.
3. REAR MOUNTS
Fully loosen the tilt hinge set screws. Slide the tilt hinges to desired
location along the top side of the collector (Figure 7).
Leave a 1” space between the tilt hinges. Tighten set screw with a 7/16”
wrench to a maximum of 10 foot pounds to lock the flush mount into
position. See Figure 8.
Position the E1022 struts between the two tilt hinges on each side
and align the hole in the strut with holes in the tilt hinge. Insert the
4” x 3/8” bolt through all three pieces and secure with a 3/8” nut
and washer.
Figure 5: Hinge to triangle foot
Figure 6: Triangle foot
Figure 7: Rear mount detail
Figure 9: Installed rear mount detail
Figure 8: Rear mount