HTP FP-40SC - Manual (Page 20)

20
E. RACK MOUNTS (HTP Part # FP-RM)
Each rack mount package contains enough hardware to secure one
collector.
The set contains:
• (4) Rack mounts
• ¼” – 20 stainless steel set screws, pre-installed per flush mount
INSTALLATION
Fully loosen the set screw. Once loosened, the rack mount will
engage into the Quick Lock frame rail. Slide the rack mount to the
desired location.
Tighten set screw with a 7/16” wrench to a maximum of 10 foot pounds
to lock the rack mount into position (Figure 15).
PART 5 – ROOF / WALL ATTACHMENT SUGGESTIONS
Working on the roof is extremely dangerous. Plan the installation carefully such that a safe distance from
the edge can be maintained. Sure footing is also required. Be sure to wear sturdy, rubber soled shoes.
NO SANDALS OR FLIP FLOPS. Harnessing equipment for fall prevention is mandatory.
Be sure that the roof is dry before beginning installation. Be sure that any ladders are set firmly against
the side of the building and mounted properly. Have someone hold the ladder for you while you climb.
Be aware of any electric or water lines before drilling into the roof. Plan the installation accordingly.
The following page details suggested roof attachment methods:
Figure 13: Rack mount
hardware
Figure 15: Rack mount detail of
tightening screws to frame
Figure 14: Rack mount clamp