HTP FP-40SC - Manual (Page 7)

7
C. HIGH TEMPERATURES
• In sunlight, the copper plumbing ports can reach temperatures in excess of 300 o
F. Thick leather
gloves must be worn when handling hot components to prevent serious burns.
• Keep solar hot water system and components away from children and animals.
• In an installed, fully plumbed system, if the pump is stopped in sunny conditions, the copper ports
and piping can easily reach temperatures in excess of 300
o
F. Caution should be taken when
handling such components.
• Do not store combustible materials (dry leaves, tree branches, gasoline, etc.) in the vicinity of the
solar system.
Failure to follow these warnings could lead to property damage, serious personal injury, or death.
D. SAFETY PRECAUTIONS
• Wear leather gloves when handling metal components and hot plumbing components.
• Adhere to safety regulations when working on roofs (or at a height).
• Always obtain engineer approval for installations in high wind regions.
• Assembly of the solar hot water system requires two persons with the ability to lift 75 pounds
each.
• It is best to install the solar hot water system on a cool, cloudy day.
If any system components are exposed to the following, do not operate until the affected component has
been inspected by a qualified serviceman.
1. FIRE
2. DAMAGE
3. SUBMERSION IN WATER
Any claims for damage or shortage in shipment must be filed immediately against the transportation
company by the consignee.
Use of lead solder is expressly prohibited. Use of galvanized steel, CPVC, PVC, PEX, or any other type
of plastic pipe is prohibited.
E. TEMPERATURE LIMITATION
To prevent scalding, the high temperature of the potable water must be limited using an ASSE 1016
tempering valve. This valve is usually located between the hot water storage tank and faucets in
bathrooms, kitchens, etc. Tempering valves are mandatory under most codes and usually set to a
maximum of 120
o
F. Tempering valves must be rated for high-temperature solar use.
PART 2 – IMPORTANT INFORMATION
A. SCOPE OF MANUAL
This manual pertains only to the installation and operation of the HTP solar collector. Details for the
installation, operation, and maintenance of the complete solar gas/electric water heating system,
including, but not limited to: the storage tank, gas/electric booster, pump, system controller, valves, and
other plumbing components, should be provided separately by their respective manufacturers.
NOTE: This manual is primarily a reference document for authorized installation individuals, as the solar
collector is not permitted to be installed by non-authorized persons.