IAI America IX-NNC8040 - Manual (Page 19)

13
2. T
ransportation and Handling
2.3 Handling of Individual Components
The robot and controller are supplied as a set.
Your robot cannot be used with the controller supplied with another robot.
When handling multiple robots, be careful not to lose their correct pairings with the controllers.
The robot will not stand on its own after being unloaded from the carton pallet.
Hold it by hand, or place a cushioning material on the floor and place the robot on its side upon the cushion.
2.4 Checking after Unpacking
After unpacking the carton, check the condition of the robot and other items contained in the carton.
Standard parts Optional parts
Robot 1 PC software (type: IA-101-X-MW)
Controller 1 Floppy disk 2
Operation manual for robot 1 PC connection cable 1
Operation manual for controller 1 Hand-held emergency-stop switch 1
Operation manual for PC software 1
Absolute reset adjustment jig
Accessories
Type: JG-1 (IX-NNC50
, IX-NNC60 )
Eyebolt 2 JG-3 (IX-NNC70 , IX-NNC80 )
D-sub connector 1 Positioning jig for axes 1 and 2 1
Hood set (for D-sub connector) 1 Positioning jig for axis 4 1
Caution label 2
Positioning label 1
PIO flat cable 1
z Always operate the robot using the controller supplied with the robot in the same carton. Using
another controller may result in an unexpected operation, damaged motor or other problem.
z After unpacking, be sure to confirm the condition of the robot and other items contained in the
carton. Should you find a damaged or missing part, please contact IAI immediately.
Note Caution