IAI America IX-NNC8040 - Manual (Page 43)

37
6. Inspection/Maintenance
6.3 How to Check/Adjust Belt Tension
6.3.1 Preparation
The following tools are required when checking/adjusting belt tension:
x Push-pull gauge (maximum measurement capability of 2 kg)
x Hex wrenches (2.5, 3 and 4 mm)
x Spanners (5.5 and 8 mm)
x Phillips screwdriver
x Scale
x Pin (I3, 40 to 80 mm in length)
Turn off the power to the controller. Do not cut off the 24 VDC power supply to the brake.
z Performing inspection or maintenance without fully understanding the details of work may result in
a serious accident.
z If inspections are neglected, the drive part may wear prematurely or the robot may malfunction
unexpectedly.
z Display a “Work in Progress” sign so that other operators will not operate the controller, operation
panel, etc.
Caution Warning