Caution, 8 installing the cover – IAI America IX-NNW8040 User Manual
Page 47
41
6. Inspection/Maintenance
6.3.8 Installing the Cover
(1) Place the cover on the robot and connect the connectors, cables and air tubes installed as illustrated
below. (Absolute reset, as described on the following page, is not required after the belt tension is only
checked.)
z Check the marking tubes to prevent improper connections.
z Be careful not to bend the air tubes.
z Be careful not to let the cables contact the pulley.
z Check if the connectors are fully inserted.
z Be careful not to pinch the cables.
z Disassembling the cover provides opportunities for water and powder dust to enter the robot.
Always disassemble the cover in an appropriate environment where water/powder dust will not
enter the robot.
[2] 4 - M3 x 20
[1] 4 - M3 x 18
Installation position
of PG connector
PG cable
Caution
Sealing washer